HFEVC-TY350
Product Features
- Ceramic vacuum brazing seal is adopted to ensure no arc leakage, and the contact point can meet the protection grade of IP6K9K.
- The mixed gas mainly filled with hydrogen can quickly cool the arc and prevent the contact from oxidation and burning
- 350A 85°C long time current carrying capacity
- The rated voltage of cut-off load is 12-750VDC
- The insulation resistance reaches 1000m Ω (1000VDC) and meets the requirements of IEC 60664-1
- Energy saving type: control by wide voltage PWM board ,when at low power consumption, product can keep in incentive condition.
- It can be equipped with auxiliary contact to effectively monitor the on-off of main contact.
- There is no polarity requirement for load and coil.
Outline drawing, mounting hole size：
Mounting hole size/Wiring diagram：
Precautions For Use
1. To prevent looseness, please use gasket when installing contactor. Please install the contactor and load outlet in the way specified in the table below, and control the torque within the required range. In case of exceeding the range, the contactor may be damaged.
2.Please to avoid sticking grease and other foreign bodies on the leading-out piece, and use the connection wire of 150mm² or above, otherwise abnormal heating may be caused at the leading-out end.
3. It is suggested that the thickness of copper strip is 5mm, otherwise it will cause the problem of thread sliding teeth or loose installation.
Statement
1. The document is for customer reference only. Huanfang has made every effort to ensure the accuracy of the information in this document. However, mistakes are inevitable, and the products, specifications and parameters may be changed due to product improvement. For the specific parameters and performance of each product, please refer to the specifications and samples provided by Huanfang without further notice.
2. As for the application field, it is impossible for Huanfang to evaluate all performance parameters of contactor in each specific application field. Therefore, customers should select the products matching with the contactor according to the specific service conditions. If the requirements are not specified clearly, please contact Huanfang for more technical support. Huanfang clearly states that the information in this document is only for selection reference, and the responsibility of product selection is only the responsibility of the customer.
